Dodge Nitro: Hazard warning flasher
The Hazard Warning Flasher switch is located on the lower switch bank below the climate controls.
Press the switch to turn on the
Hazard Warning
flasher. When the switch is activated, all directional
turn signals will flash on and off to warn oncoming
traffic of an emergency. Press the switch a second time to
turn off the Hazard Warning flasher.
This is an emergency warning system and should not be
used when the vehicle is in motion. Use it when your
vehicle is disabled and is creating a safety hazard for
other motorists.
If it is necessary to leave the vehicle to go for service, the
HazardWarning flasher will continue to operate with the
ignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flasher may wear down your battery.
If your engine overheats
In any of the following situations, you can reduce the
potential for overheating your engine by taking the
appropriate action.
• On the highways — slow down.
• In city traffic — while ...
See also:
If you have a flat tire
The spare tire, jack, jack handle, wheel lug nut wrench are stored in the luggage
compartment. Remove the luggage under tray out of the way to reach this equipment.
Removing the spare tire Turn ...
Manual transmission models
Manual transmission models
The key can be turned from “Acc” to
“LOCK” only when the key is pushed in
while turning it. ...
Releasing the electric parking brake
Parking brake control
Manual release
1. Fasten the seat belt.
2. Insert the remote key in the ignition slot (or
press the START/STOP ENGINE button
on vehicles with the optional keyless drive) ...
