Range Rover Evoque: Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access: 1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. The fuse box can now be opened.
The engine compartment fuse numbers and positions are shown on the inside of the fuse box cover.
Passenger compartment - fuse box access.
There are two covers.
4. To access the upper part, open the glovebox and remove the panel from the glovebox liner. A label on the panel shows the circuits protected and the fuse locations.
5. To access the lower part, remove the lower access panel.
Luggage compartment - fuse box access: 6. Remove the panel from the left side trim of the luggage compartment.
READ NEXT:
Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching sp
SEE MORE:
Rear View
Mirror
Headlamp Control Module B (HCMB)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If
Electric parking brake (EPD)
The parking brake operates on
the rear
wheels. Therefore, secure parking of
the vehicle is dependent on being on a
hard and stable surface.
Do not rely on the parking brake to
operate effectively, if the rear wheels
have been immersed in mud or water.
Note: If the vehicle is used in severe
