Ford Escape: Erasing the Car2U Home Automation System buttons
Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used.
To erase programming on the Car2U system (individual buttons cannot be erased), use the following procedure:
1. Firmly press the two outside Car2U system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons.
2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased.
If you sell your vehicle equipped with the Car2U system, it is recommended that you erase the programming for security reasons.
Fixed code programming
Note: Do not program the Car2U system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP swi ...FCC and RSS-210 Industry Canada Compliance
The Car2U system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, ...See also:
Traction Control System (TCS)
This system monitors the amount of wheel spin of each of
the driven wheels. If wheel spin is detected, brake
pressure is applied to the slipping wheel(s) and engine
power is reduced to provide e ...
Summary
• The camera is activated when the gear
selector is moved to R (this can be
changed in the MY CAR menu) and the image is shown on the center console
display.
• When backing up, two solid li ...
Setting a speed
WARNING
Keep in mind that it may take a brief moment until the vehicle has made the necessary
adjustments.
Increase or decrease the set vehicle speed to a value that the prevailing road
con ...