Range Rover Evoque: Epb manual use
Epb manual use
1. To apply the parking brake, with the vehicle stationary, pull up the lever and release it.
The parking brake warning lamp will illuminate. It is important to confirm that the lamp is continuously illuminated (not flashing), as this indicates the brake has been correctly applied.
If the lever is operated when the vehicle speed is less than 3km/h (2mph) the vehicle will be brought to an abrupt stop.
The stop lamps will not be illuminated.
If a fault is detected the warning lamp will flash and a PARKBRAKE message will be displayed in the message centre.
Note: The red brake warning indicator will continue to be illuminated for at least ten seconds after the ignition has been turned off.
2. To release the parking brake, press the brake pedal and press down on the EPB lever.
Driving the vehicle with the
parking
brake applied, or repeated use of the
parking brake to slow the vehicle, may
cause serious damage to the brake
system.
In an emergency, with the vehicle travelling more than 3km/h (2mph), pulling on the EPB lever and holding gives a gradual reduction in speed. The brake warning indicator will illuminate accompanied by a warning tone and a PARKBRAKE message appearing in the message centre. The stop lamps will illuminate.
READ NEXT:
Epb automatic use
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EP
Epb warning indicators
If the system detects a fault with the EPB, the
amber brake warning indicator will illuminate
accompanied by a message on the message
centre.
If the system detects a fault while EPB is
operating,
SEE MORE:
Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.
Side Panel Dimensions
3-door version
5-d
High beam assist
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only active when the ambient light drops below
a predetermined level.
Note: It is not recommended that high
