Dodge Nitro: Engine block heater
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
• The engine block heater cord is found under the hood
clipped to the heater line on the left side of the engine.
WARNING: Remember to disconnect the cord before driving. Damage to the 110-115 Volt AC electrical cord could cause electrocution.
Use the heater when temperatures below 0 °F (-18 °C) are expected to last for several days.
Starting procedures
Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING: Never leave children alone in a vehicle. Leaving children in a vehic ...Automatic transmission
CAUTION: Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of ...See also:
Emergency Tensioning Devices, belt force limiters
The front seat belts and the outer seat belts in the rear are equipped with ETDs
and seat belt force limiters.
The ETDs tighten the seat belts in an accident, pulling them close against the
body. ...
Display Units In
The EVIC can be changed between English and Metric
units of measure. The units apply to the Outside Temperature,
Average Fuel Economy, Distance to Empty, and
Tire Pressure displays. To make your ...
Remote Keyless Entry (RKE)
This system allows you to lock or unlock the doors and
liftgate, open the liftgate flip-up window, or activate the
PANIC alarm from distances up to approximately 66 ft
(20 m) using a hand-held R ...