Four-wheel drive lock switch (4WD models)

Four-wheel drive lock mode can be used when a large amount of drive power needs to be applied to all the wheels, such as when the vehicle gets stuck in mud and you need to free it. Press the swit ...

Utility vehicle precautions

This vehicle belongs to the utility vehicle class, which has higher ground clearance and narrower tread in relation to the height of its center of gravity to make it capable of performing in a wide ...

See also:

Tilt position
Tilt position, raised at the rear edge 1 Open (raise the rear edge of the front glass section) by pressing the rear edge of the control upward. 2 Close by pulling the rear edge of the control ...

Canceling the function for meter/gauge needle movement upon turning on the ignition switch
Type A Type B It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position. ...

Driver Alert Control (DAC)– introduction
This function is intended to alert the driver if his/her driving becomes erratic, such as if the driver is distracted or fatigued. NOTE The camera has certain limitations, see page 159. A c ...