Nissan Rogue: Connecting iPod®
To connect an iPod® to the vehicle so that the iPod® can be controlled with the audio system controls and display screen, use the USB jack located in the center console. Open the protective cover on the USB jack in the center console and then connect the iPod® specific end of the cable to the iPod® and the USB end of the cable to the USB jack on the vehicle 1 .
If your iPod® supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position.
While connected to the vehicle, the iPod® can only be operated by the vehicle audio controls.
To disconnect the iPod® from the vehicle, remove the USB end of the cable from the USB jack on the vehicle, then remove the cable from the iPod®.
* iPod® is a trademark of Apple Inc., registered in the U.S. and other countries.
Compatibility
The following models are available: - Fifth generation iPod® (version 1.2.3 or later) - iPod Classic (version 1.1.1 or later) - First generation iPod touch® (version 2.0.0 or later) - Se ...See also:
Driving downhill
Drive slowly.
Do not drive at an angle down steep inclines. Steer into the line of fall
and drive with the front wheels aligned straight. Otherwise, the vehicle could
slip sideways, tip and ...
Defrosting or defogging the windshield
Defrosting or defogging the windshield
To direct warm air to the windshield and
front door windows:
1. Set the airflow control dial to the “”
position.
2. Turn the temperature control ...
Rear fog light
The rear fog light (located on the driver's side
of the vehicle) can be reached from behind the
bumper
1. Remove the bulb holder by turning it counterclockwise.
2. Remove the burned out bulb ...