Nissan Rogue: Checking the tire pressure
1. Remove the valve stem cap from the tire.
2. Press the pressure gauge squarely onto the valve stem. Do not press too hard or force the valve stem sideways, or air will escape. If the hissing sound of air escaping from the tire is heard while checking the pressure, reposition the gauge to eliminate this leakage.
3. Remove the gauge.
4. Read the tire pressure on the gauge stem and compare it to the specification shown on the Tire and Loading Information label.
5. Add air to the tire as needed. If too much air is added, press the core of the valve stem briefly with the tip of the gauge stem to release pressure. Recheck the pressure and add or release air as needed.
6. Install the valve stem cap.
7. Check the pressure of all other tires, including the spare.
1: 2WD models
2: AWD models
3: AWD models with 18 inch tires
Tire and Loading Information label
1 Seating capacity: The maximum number
of occupants that can be seated in the
vehicle.
2 Vehicle load limit: See “Vehicle loading
information” in the “9. Technical and
consumer inform ...
Tire labeling
Example
Federal law requires tire manufacturers to
place standardized information on the sidewall
of all tires. This information identifies
and describes the fundamental characteristics
of ...
See also:
Draining Fluid
First remove the fill plug (1), then the drain plug (2).
Recommended tightening torque for the drain and fill
plugs is 15–25 ft lbs (20–34 N·m).
CAUTION!
Do not over-tighten the plugs. You ...
Manual Liftgate
To unlock the liftgate, press the power door lock switch or press " on the Remote
Keyless Entry (RKE) transmitter twice. See Remote Keyless Entry (RKE) System Operation
on page 2‑3. To ...
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst ...
