Subaru Forester: Checking the fluid level when the fluid is cold
When the fluid level has to be checked without time to warm up the automatic transmission, check to see that the fluid level is between the lower level and upper level on the “COLD” range. If it is below that range, add fluid up to the upper level.
Be careful not to overfill.
Be careful not to spill automatic transmission fluid when adding it.
If automatic transmission fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If automatic transmission fluid gets on the exhaust pipe, be sure to wipe it off.
Checking the fluid level when the fluid is hot
1. Drive the vehicle several miles to raise
the temperature of the transmission fluid
up to normal operating temperature; 158
to 1768F (70 to 808C) is normal.
2. Park the vehicle on a level sur ...
Recommended fluid
Refer to “Fluids”.
NOTE
Using any non-specified type of automatic
transmission fluid could result in
damage inside the transmission. When
replacing the automatic transmission
fluid, be ...
See also:
Maximum trailer loads
Never allow the total trailer load to exceed the
value specified in the “Towing Load/Specification”
chart. The total trailer load equals trailer
weight plus its cargo weight.
- When towing ...
Instrument Panel Brightness
You can change the instrument panel
brightness only when the light
switch is on.
Turn the knob on the lower part of
the instrument panel to adjust the
brightness.
You will hear a beep wh ...
KEYLESS-GO
General information
Vehicles with KEYLESS-GO are equipped with a SmartKey featuring an integrated
KEYLESSGO function and a detachable Start/Stop button.
The Start/Stop button must be inserted into ...
