Jeep Liberty: Call Termination
To end a call in progress, momentarily press the button. Only the active call(s) will be terminated and if there is a call on hold, it will become the new active call.
If the active call is terminated by the phone far end, a call on hold may not become active automatically. This is cell phone-dependent. To bring the call back from hold, press and hold the button until you hear a single beep.
Three-Way Calling
To initiate three-way calling, press the button while a call is in progress, and make a second phone call, as described under “Making a Second Call While Current Call is in Progress”. Afte ...Redial
• Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...See also:
Immobilizer
The immobilizer prevents your vehicle from being started without the correct
SmartKey.
When leaving the vehicle, always take the SmartKey with you and lock the vehicle.
The engine can be started ...
Warranty Coverages
U.S. Owners
Your new vehicle is covered by these
warranties:
New Vehicle Limited Warranty - covers your new vehicle, except for
the battery, emissions control
systems, and accessories against ...
Deactivating the alarm when triggered
If the alarm has been triggered, it can be
deactivated by any one of the following
methods:
- Pressing the unlock button on the Smart
Key.
- Opening a door using keyless entry.
- Positioning a v ...