Subaru Forester: Brake assist system - Brake system - Braking - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: Brake assist system

Do not be overconfident about the

Do not be overconfident about the brake assist. It is not a system that brings more braking ability to the vehicle beyond its braking capability.

Always use the utmost care when driving regarding vehicle speed and safe distance.

When you need to brake suddenly, continue depressing the brake pedal strongly to bring the effect of the brake assist.

Brake assist is a driver assistance system.

It assists the brake power when the driver cannot depress the brake pedal strongly and the brake power is insufficient.

Brake assist generates the brake power according to the speed at which the driver depresses the brake pedal.

NOTE
When you depress the brake pedal strongly or suddenly, the following phenomena occur. However, even though these occur, they do not indicate any malfunctions, and the brake assist system is operating properly.

- You might feel that the brake pedal is applied by lighter force and generates a greater braking force.

- You might hear clicking (knocking) sounds around brake pedal.

    Brake booster
    The brake booster uses engine manifold vacuum to assist braking force. Do not turn off the engine while driving because that will turn off the brake booster, resulting in poor braking power. ...

    Disc brake pad wear warning indicators
    Disc brake pad wear warning indicators The disc brake pad wear warning indicators on the disc brakes give a warning noise when the brake pads are worn. If a squeaking or scraping noise is he ...

    See also:

    Calibrating the compass
    Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic. In order to calibrate the compass correctly, observe the following points: ca ...

    Disc
    To switch to the disc mode, say “Disc”. In this mode, you may say the following commands: • “Track” (#) (to change the track) • “Next Track” (to play the next track) • “Pre ...

    Programming A Rolling Code
    For programming garage door openers that were manufactured after 1995. These garage door openers can be identified by the “LEARN” or “TRAIN” button located where the hanging antenna is a ...