Volvo XC60: Automatic standby mode
Adaptive cruise control is linked to other systems such as the stability and traction control system (DSTC). If this system is not functioning properly, adaptive cruise control is automatically deactivated and will go into standby mode.
In the event of automatic deactivation, an audible signal will sound and the message Cruise control Cancelled is shown in the display.
The driver must then intervene and adapt the vehicle's speed to the surrounding traffic and regulate the distance to the vehicle ahead.
An automatic switch to standby mode may be
caused if:
• the wheels lose traction
• brake temperature is high
• the radar sensor is obstructed by, for
example, wet snow or rain.
Standby mode due to action by the driver
ACC is temporarily deactivated and put in
standby mode:
• when the brakes are applied
• if the driver's seat belt is taken off
• If the driver's door is opened
• if the gear selector is ...
Queue Assist
The following functions are linked to your vehicle's
automatic transmission and comprise the
Queue Assist feature.
Please note that the lowest speed that can be
set is 18 mph (30 km/h), althoug ...
See also:
Adding engine oil
1. Check the engine oil. For instructions, refer to Checking the engine
oil in this chapter.
2. If the engine oil level is not within the normal range, add only certified
engine oil of the recommen ...
Windows
Power Windows
The power window controls are located on the driver’s
door trim panel. There is a single switch on the front
passenger/rear passenger doors which operates the front
passenger/re ...
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult ...
