Subaru Forester: Adjusting the front seat shoulder belt anchor height
Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle of the shoulder without touching the neck.
To raise:
Slide the anchor up.
To lower:
Pull the release knob and slide the anchor
down.
Pull down on the anchor to make sure that it is locked in place.
When wearing the seatbelts, make sure the shoulder portion of the webbing does not pass over your neck. If it does, adjust the seatbelt anchor to a lower position. Placing the shoulder belt over the neck may result in neck injury during sudden braking or in a collision.
Front seatbelts
1. Adjust the seat position according to
the following procedure.
Driver’s seat: Adjust the seatback to the
upright position. Move the seat as far from
the steering wheel as practical while s ...
Unfastening the seatbelt
Unfastening the seatbelt
Push the button on the buckle.
Before closing the door, make sure that
the belts are retracted properly to avoid
catching the belt webbing in the door. ...
See also:
Error Messages
If Disc Error displays and/or the disc comes out, it could be for one of the
following reasons:
○ The disc has an invalid or unknown format.
○ The disc is very hot. Try the disc again ...
Rain sensor
The rain sensor automatically regulates wiper
speed according to the amount of water on the
windshield. The sensitivity of the rain sensor
can be adjusted moving the thumb wheel up (the wipers w ...
Menu settings
The default settings for four of the climate system's
functions can be changed in the menu
system.
• Blower speed in automatic mode.
• Recirculation timer for passenger compartment
air.
â ...
