Honda CR-V: Vanity Mirror

To use the vanity mirror on the back

To use the vanity mirror on the back of the sun visor, pull up the cover.

Except LX model

The vanity mirror lights come on when you pull up the cover.

READ NEXT:

 Sun Visor

To use the sun visor, pull it down. When using the sun visor for the side window, remove the support rod from the clip, and swing it out. Make sure you put the sun visor back in place when

 Sunglasses Holder

To open the sunglasses holder, push then release the raised detent. It will unlatch and swing down. To close it, push it until it latches. Make sure the holder is closed while you are driv

 ConversationMirror

The sunglasses holder uses a convex mirror for its bottom panel. You can see all the vehicle passengers in this mirror. To use the mirror, open the sunglasses holder fully, push it to the

SEE MORE:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

 Seat Belt System Components

Your seat belt system includes lap/ shoulder belts in all seating positions. The front seat belts are also equipped with automatic seat belt tensioners. This system uses the same sensors as the front airbags to monitor whether the front seat belts are latched or unlatched, and how much

© 2016-2024 Copyright www.hcrv.net