GMC Terrain: Turn and Lane-Change Signals
An arrow on the instrument panel cluster will flash in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is complete. If the lever is briefly pressed and released, the turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or a lane change the arrows flash rapidly or do not come on, a signal bulb may be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse; see Fuses on page 10‑38 for more information.
Hazard Warning Flashers
(Hazard Warning Flasher): Press
this button, on the center of the instrument panel, to make the front and rear turn
signal lamps flash on and off. This warns others that you are having trouble. ...
Fog Lamps
The fog lamps control is located on the turn/lane change lever.
Use the fog lamps for better vision in foggy or misty conditions.
FOG (Fog Lamps): Turn the fog lamp
band on the lever to and re ...
See also:
Use of engine braking
Remember to make use of engine braking
in addition to foot braking. When descending
a grade, if only the foot brake is used,
the brakes may start working improperly
because of brake fluid over ...
Storing settings
With the memory function, you can store up to three different settings, e.g.
for three different people.
The following settings are stored as a single memory preset:
position of the seat, backr ...
NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using the registered
key, it may be due to interfere ...
