Jeep Liberty: Transfer Case Position Indicator Lights
The four-wheel drive indicator lights (4WD and 4 LOW) are located in the instrument cluster. The NEUTRAL indicator light is located on the transfer case switch. If there is no indicator light on or flashing, the transfer case position is two-wheel drive (2WD). If the indicator light is on, the desired position (4WD LOCK, 4WD LOW, or NEUTRAL) has been obtained.
If One Or More Shift Requirements Are Not Met:
• An indicator light will flash.
• The transfer case will not shift.
NOTE: The “SERV 4WD Warning Light” monitors the electric shift four-wheel drive system. If this light remains on after engine start up, or it illuminates during driving, it means that the four-wheel drive system is not functioning properly and that service is required.
Shift Positions
The transfer case switch is located on the center console
next to the shift lever.
Transfer Case Switch
2WD
Rear Wheel Drive High Range - This range is used for
normal street and highway driv ...
Shifting Procedures
NOTE: If any of the requirements to select a new
transfer case position have not been met, the transfer case
will not shift, the indicator light for the previous position
will remain on, and the ...
See also:
Touch screen care
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain opti ...
Replacing a Front Turn Signal Light Bulb
1. Open the hood.
To change the turn signal bulb on
the driver’s side, remove the
engine coolant reserve tank by
pulling it out of its holder.
2. Remove the socket from the
headlight a ...
Engine Identification
The eighth character in the VIN is the engine code. This code identifies the
vehicle's engine, specifications, and replacement parts. See “Engine Specifications”
under Capacities and Speci ...