Nissan Rogue: Training procedure - Speaker Adaptation (SA) mode - Bluetooth® Hands-Free Phone System (if so equipped) - Center display, heater, air conditioner, audio, phone and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: Training procedure

1. Position the vehicle in a reasonably quiet outdoor location.

2. Sit in the driver’s seat with the engine running, the parking brake on, and the transmission in Park.

3. Push and hold the 5 seconds. button for more than 5 seconds.

4. The system announces: “Push the PHONE SEND ( button for the hands-free ) button for the hands-free phone system to enter the speaker adaptation mode or push the PHONE END (button to select a different language.” ) button to select a different language.” 5. Push the button. button.

For information on selecting a different language, see “Choosing a language” earlier in this section.

6. If the connected phone is already in use, the system will prompt you to overwrite. Follow the instructions provided by the system.

7. When preparation is complete and you are ready to begin, push the 8. The SA mode will be explained. Follow the button.

8. The SA mode will be explained. Follow the instructions provided by the system.

9. When training is finished, the system will tell you an adequate number of phrases have been recorded.

10. The system will announce that speaker adaptation has been completed and the system is ready.

The SA mode will stop if:
- The is pushed for more than 5 button is pushed for more than 5 seconds in SA mode.

- The vehicle is driven during SA mode.

- The ignition switch is turned to the OFF or LOCK position.

    Speaker Adaptation (SA) mode
    Speaker Adaptation allows up to two out-of dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own ...

    Training phrases
    During the SA mode, the system instructs you to say the following phrases. (The system will prompt you for each phrase.) - phonebook transfer entry - dial 3 0 4 2 9 - delete call back number ...

    See also:

    Preparing to Drive
    You still need to exercise the same care when accelerating, steering, and braking that you would in a twowheel drive vehicle. 1. Make sure all windows, mirrors, and outside lights are clean a ...

    Towing Assistance
    If you need towing assistance: • Press the button to begin. • After the “Ready” prompt and the following beep, say “Towing Assistance”. NOTE: • The towing assistance number dia ...

    Headlamp High/Low-Beam Changer
    Headlamp High/Low&-Beam Changer: Push the turn signal/lane change lever away from you and release, to turn the high beams on. To return to low beams, push the lever again or pull it toward yo ...