Jeep Liberty: Voice Training
For users experiencing difficulty with the system recognizing their voice commands or numbers, the Uconnect™ Phone Voice Training feature may be used. To enter this training mode, follow one of the two following procedures:
From outside the Uconnect™ Phone mode (e.g., from
radio mode):
• Press and hold the button for
five seconds until
the session begins, or,
• Press the button and say the
“Voice Training,
System Training, or Start Voice Training” command.
You can either press the Uconnect™ Phone button to restore the factory setting or repeat the words and phrases when prompted by the Uconnect™ Phone. For best results, the Voice Training session should be completed when the vehicle is parked with the engine running, all windows closed, and the blower fan switched off.
This procedure may be repeated with a new user. The system will adapt to the last trained voice only.
Uconnect™ Phone Tutorial
To hear a brief tutorial of the system features, press the button and say “Uconnect™ Tutorial.” ...Reset
• press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in ...See also:
Voice tutorial
To listen to a tutorial detailing the operation of
the Voice system:
- Briefly press the Voice button to start a
voice session.
- Wait for the tone to sound, then say Voice
tutorial.
Alternative ...
Front seat heaters
Press the relevant button to operate the
required seat heater at high level. Three
indicators will illuminate.
Press a second time to heat the seat at a
medium level. Two indicators will illuminat ...
Head restraints
Head restraints are provided for all seats.
Front seats
1 Up
Pull the head restraints up.
2 Down
Push the head restraint down
while pushing the lock release
button.
Second seats
1 Up
Pul ...