Volvo XC60: Using City Safety
NOTE
The City Safetyâ„¢ function is activated automatically
each time the engine has been
switched off and restarted.
On and Off
In certain situations, it may be desirable to switch City Safetyâ„¢ off, such as when driving in close quarters where leaves, branches, etc.
may obscure the hood and windshield.
When the engine is running, City Safetyâ„¢ can be switched off as follows:
Press My Car in the center console control panel and go to Settings Car settings Driver support systems City Safety.
Select Off.
If the engine is switched off, City Safetyâ„¢ will reactivate when the engine is restarted.
WARNING
The laser sensor emits light when the ignition
is in mode II or higher, even if City
Safetyâ„¢ has been switched off.
To switch City Safetyâ„¢ on again:
• Follow the same procedure as for switching City Safety™ off but select ON.
Function
Location of the laser sensor in the windshield City Safetyâ„¢ monitors traffic ahead of you using a laser sensor mounted in the upper section of the windshield. If a collision is imminent, Ci ...Limitations
The sensor used by City Safetyâ„¢ is designed to detect cars and other larger motor vehicles ahead of your vehicle in both daylight and darkness. However, there are certain limitations and the ...See also:
Replacement Bulbs
For replacement bulbs not listed here, contact your dealer. ...
Passenger compartment filter
Replace the cabin air filter with a new one at
the recommended intervals. Please refer to
your Warranty and Service Records Information
booklet, or consult a trained and qualified
Volvo servic ...
Power distribution box
The power distribution box is located in the engine compartment. Refer
to the Identifying components in the engine compartment section of
the Maintenance and Specifications chapter for the location. ...