Honda CR-V: Tire Inspection

Every time you check inflation, you should also examine the tires for damage, foreign objects, and wear.

You should look for:

Bumps or bulges in the tread or side of the tire. Replace the tire if you find either of these conditions.

Cuts, splits, or cracks in the side of the tire. Replace the tire if you can see fabric or cord.

Excessive tread wear.

Your tires have wear indicators

Your tires have wear indicators molded into the tread. When the tread wears down, you will see a 1/2 inch (12.7 mm) wide band across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the tire.

A tire this worn gives very little traction on wet roads. You should replace the tire if you can see three or more tread wear indicators.

READ NEXT:

 Tire Service Life

The service life of your tires is dependent on many factors, including, but not limited to, driving habits, road conditions, vehicle loading, inflation pressure, maintenance history, speed,

 Tire Maintenance

In addition to proper inflation, correct wheel alignment helps to decrease tire wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment. Have your dealer check t

 Tire Rotation

To help increase tire life and distribute wear more evenly, rotate the tires according to the maintenance messages displayed on the information display.Move the tires to the positions show

SEE MORE:

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid inspection oil filler plug. 3. Remove the oil filler plug (A) and the sealing washer (B), then check

 VSA (Vehicle Stability Assist) System Components

Component Location Index VSA MODULATOR-CONTROL UNIT Removal and Installation UNDER-HOOD FUSE/RELAY BOX DATA LINK CONNECTOR (DLC) STEERING ANGLE SENSOR Replacement VSA OFF SWITCH Test RIGHT-REAR WHEEL SENSOR Replacement HUB BEARING UNIT (MAGNETIC ENCODER) Replace

© 2016-2024 Copyright www.hcrv.net