Subaru Forester: Rear center seating position
The head restraint is not intended to be used at the lowest position.
Before sitting on the seat, raise the head restraint to an appropriate position depending on your sitting height.
A) When not used (retracted position)
B) When used (click position)
1) Head restraint
2) Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks.
When the rear-center seating position is occupied, raise the head restraint to an appropriate position depending on your sitting height. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
Rear windows side seating position
Rear windows side seating position
1) Head restraint
2) Release button
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into ...
Reclining the seatback (if equipped)
To prevent the passenger from sliding
under the seatbelt in the event of
a collision, always put the seatback
in the upright position while the
vehicle is in motion. Also, do not
place ...
See also:
Trailer Towing
Before pulling a trailer, there are three important considerations that have
to do with weight:
○ The weight of the trailer
○ The weight of the trailer tongue
○ The total weight ...
Daily Inspection Checklist
Before Driving
1) Make sure that windows, mirrors, lights and reflectors are clean and unobstructed.
2) Visually check the tires for the following points: – the depth of the tread groove.
– a ...
How to use remote keyless entry system
How to use remote keyless entry system
1 LOCK button
2 UNLOCK button
3 PANIC button ...
