Jeep Liberty: Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Required” message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON position. To turn off the message temporarily, press and release the SELECT button. To reset the oil change indicator system (after performing the scheduled maintenance), perform the following procedure:
1. Turn the ignition switch to the ON position. Do not start the engine.
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition switch to the LOCK position.
NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.
Electronic Vehicle Information Center (EVIC) Displays
When the appropriate conditions exist, the EVIC displays
the following messages:
• Low Tire Pressure
• Spare Low Pressure
• Premium TPMS Graphic Display
• Key in Ignition
• Turn ...
EVIC Main Menu
To step to each main menu feature press and release the
MENU button once for each step. A step from the last
item in the list will cause the first item in the feature list
to be displayed. The f ...
See also:
Fuel Gauge
This shows how much fuel you have.
It may show slightly more or less
than the actual amount.
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to ...
Dimensions
*1: Measured with vehicle empty ...
Trailer levelling
To maintain vehicle stability, it is essential that
the trailer is loaded so that it remains parallel to
the ground. This is particularly important when
towing twin axled trailers.
Vssential towin ...