Toyota RAV4: Instrument panel light control
The brightness of the instrument panel lights can be adjusted.
1 Brighter
2 Darker
When the headlight switch is turned on, the brightness will be reduced slightly unless the control dial is turned fully up.
NOTICE
■To prevent damage to the engine and its components
●Do not let the indicator needle of the tachometer enter the red zone, which
indicates the maximum engine speed.
●The engine may be overheating if the temperature gauge is in the red
zone (H). In this case, immediately stop the vehicle in a safe place, and
check the engine after it has cooled completely.
Gauges and meters
Vehicles without smart key system
The following gauges, meters and displays illuminate when the
engine switch is in the “ON” position.
Vehicles with smart key system
The following gauges, me ...
Indicators and warning lights
The indicator and warning lights on the instrument cluster and center
panel inform the driver of the status of the vehicle’s various systems.
■ Instrument cluster
■ Center panel
...
See also:
Temporary deactivation
The driver can temporarily deactivate cruise
control by pressing 0. The saved speed is
shown in brackets in the information display. ...
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...
Pre-Tow Checklist
When preparing to tow, and before
driving away, be sure to check the
following:
The vehicle has been properly
serviced, and the suspension and
the cooling system are in good
operating condi ...
