Jeep Liberty: Four–Speed Automatic Transmission
The shift lever position display (located in the instrument panel cluster) indicates the transmission gear range. You must press the brake pedal to move the shift lever out of the PARK position (refer to “Brake/Transmission Shift Interlock System” in this section). To drive, move the shift lever from PARK or NEUTRAL to the DRIVE position.
The electronically-controlled transmission provides a precise shift schedule. The transmission electronics are self-calibrating; therefore, the first few shifts on a new vehicle may be somewhat abrupt. This is a normal condition, and precision shifts will develop within a few hundred miles (kilometers).
Shifting from DRIVE to PARK or REVERSE should be done only after the accelerator pedal is released and the vehicle is stopped. Be sure to keep your foot on the brake pedal when moving the shift lever between these gears.
Shift Lever
Brake/Transmission Shift Interlock System
This vehicle is equipped with a Brake Transmission Shift Interlock (BTSI) that holds the shift lever in the PARK position unless the brakes are applied. To move the shift lever out of the PARK p ...Gear Ranges
DO NOT race the engine when shifting from PARK or NEUTRAL into another gear range. PARK This range supplements the parking brake by locking the transmission. The engine can be started in this ra ...See also:
Type A audio set (if equipped)
Type A audio set (if equipped)
The audio set will operate only when the
ignition switch is in the “Acc” or “ON”
position.
- Power and audio controls: refer to page
- Radio operation: ...
Leak Detection Pump
NOTE: Your vehicle has a pump to regularly check the vehicle’s evaporative
emission control system for leaks. This check is performed approximately five hours
after the engine is turned off. Dur ...
Wiper operation when snowing
Before driving in cold weather, make sure
the wiper blades are not frozen to the
windshield or rear window.
If the wiper blades are frozen to the
windshield or rear window, perform the
follow ...