Jeep Liberty: Exhaust Gas - Safety Tips - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Exhaust Gas

WARNING!
Exhaust gases can injure or kill. They contain carbon monoxide (CO), which is colorless and odorless.

Breathing it can make you unconscious and can eventually poison you. To avoid breathing (CO), follow these safety tips:

Do not run the engine in a closed garage or in confined areas any longer than needed to move your vehicle in or out of the area.

If it is necessary to sit in a parked vehicle with the engine running, adjust your heating or cooling controls to force outside air into the vehicle. Set the blower at high speed.

If you are required to drive with the trunk/liftgate open, make sure that all windows are closed and the climate control BLOWER switch is set at high speed. DO NOT use the recirculation mode.

The best protection against carbon monoxide entry into the vehicle body is a properly maintained engine exhaust system.

Whenever a change is noticed in the sound of the exhaust system, when exhaust fumes can be detected inside the vehicle, or when the underside or rear of the vehicle is damaged, have a competent mechanic inspect the complete exhaust system and adjacent body areas for broken, damaged, deteriorated, or mispositioned parts. Open seams or loose connections could permit exhaust fumes to seep into the passenger compartment. In addition, inspect the exhaust system each time the vehicle is raised for lubrication or oil change. Replace as required.

    Transporting Passengers
    NEVER TRANSPORT PASSENGERS IN THE CARGO AREA. WARNING! • Do not leave children or animals inside parked vehicles in hot weather. Interior heat build-up may cause serious injury or death. в ...

    See also:

    Headphones
    The volume control for each set of headphones is adjusted on the headphones. Press the channel selector button to cycle through available channels. Select the channel appropriate for the required ...

    Positions for towing hitch receiver and hitch ball
    1 Weight carrying ball position: 41.4 in. (1051.1 mm) 2 Hitch receiver pin hole position: 32.4 in. (821.8 mm) ...

    Before You Begin Programming HomeLink
    Be sure that your vehicle is parked outside of the garage before you begin programming. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended th ...