Subaru Forester: Daytime running light system (if equipped)
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system.
The light switch must always be turned to the “” position when it is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the engine has started, under the
following conditions:
- The select lever is in a position other
than the “P” position (AT models).
- The parking brake is fully released.
- The light switch is in the “OFF” or “” position.
NOTE
When the light switch is in the “”
position, the front side marker lights,
tail lights and license plate lights are
also illuminated.
Headlight flasher
Headlight flasher To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even ...Automatic headlight beam leveler (models with HID headlights)
The HID headlights generate more light than conventional halogen headlights. Therefore a driver of an oncoming vehicle may experience too much glare when your headlight beam height adjustment ...See also:
Turn signals
Turn signals
When changing lanes
1 The driver can automatically flash the turn
signals 3 times by moving the turn signal lever
up or down to the first position and releasing it.
When turning
...
Seat belt pre-tensioners
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to re ...