Hyundai Tucson: Checking the brakes - Do-it-yourself maintenance - Hyundai Tucson Owner's ManualHyundai Tucson: Checking the brakes

CAUTION: Because brakes are essential to the safe operation of the car, it is suggested that they be checked and inspected by your Hyundai dealer. The brakes should be checked and inspected for wear at those intervals specified in the vehicle maintenance schedule.

Checking the Brake Fluid Level

WARNING: Use caution when handling brake fluid. It can damage your vision if it gets into your eyes. It will also damage your vehicle's paint if spilled on it and not removed immediately.

Recommended Brake Fluid

Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specifications in your braking system. Follow the instructions printed on the container.

To Check the Fluid Level To Check the Fluid Level

The fluid level in the brake fluid reservoir should be checked periodically. The level should be between the "MIN" and "MAX" marks on the side of the reservoir. If the level is at or below the "MIN" mark, carefully add fluid to bring it up to "MAX". Do not overfill.

Adding Brake Fluid

WARNING: Handle brake fluid carefully. It can damage your vision if it gets into your eyes. Use only DOT 3 or DOT 4 specification fluid from a sealed container. Do not allow the fluid can or reservoir to remain open any longer than required. This will prevent entry of dirt and moisture which can damage the brake system and cause improper operation.

To add brake fluid, first wipe away any dirt then unscrew the fluid reservoir cap. Slowly pour the recommended fluid into the reservoir. Do not overfill. Carefully replace the cap on the reservoir and tighten.

    Checking the transaxle fluid (automatic)
    Transaxle fluid in the automatic transaxle should be checked at those intervals specified in the vehicle maintenance schedule in Section 5. NOTE: Automatic transaxle fluid is basically red co ...

    Checking the clutch fluid
    To Check the Clutch Fluid The clutch fluid level in the master cylinder should be checked when performing other under hood services. The system should be checked for leakage at the same time ...

    See also:

    Winter park position
    The wipers can be set to park in a higher position than normal. This allows the blades to be lifted from the screen to prevent freezing. The ‘Wipers winter park’ option can be selected from th ...

    Warning and Indicator lights
    SRS (Airbag) Service Reminder Indicator (SRI) The SRS service reminder indicator (SRI) comes on for about 6 seconds after the ignition key is turned to the "ON" position or after th ...

    Most common causes of corrosion
    The most common causes of corrosion are: 1. The accumulation of moisture retaining dirt and debris in body panel sections, cavities, and other areas. 2. Damage to paint and other protective ...