Hyundai Tucson: Checking drive belts
Drive belts should be checked periodically for proper tension and adjusted if necessary. At the same time, belts should be examined for cracks, wear, fraying or other evidence of deterioration and replaced if necessary. Belt routing should also be checked to be sure there is no interference between the belts and other parts of the engine. After a belt is replaced, the new belt should be adjusted again after two or three weeks to eliminate slack resulting from initial stretching after use.
Checking brake pedal clearance
You need a helper to check the brake pedal clearance. With the engine running, have your helper press down on the brake pedal several times and then hold it down with a force of about 110 lb ...Checking and replacing fuses
Replacing a Fusible Link A fusible link will melt if the electrical circuits from the battery are ever overloaded, thus preventing damage to the entire wiring harness. (This could be caused ...See also:
Handling
• Check that the battery cables are correctly
connected and tightened.
• Never disconnect the battery when the
engine is running (for example, when
replacing the battery).
• If the batte ...
Introduction
Adaptive Cruise Control (ACC) is an optional
system designed to assist the driver by maintaining
a set speed or a set time interval to the
vehicle ahead. It is primarily intended for use
on lo ...
Center console controls
Center console controls for menu navigation
1 Press MY CAR to access the My Car
menus.
2 Press OK/MENU to select a highlighted
selection or to store a certain function in
the system's memory ...