Jeep Liberty: Toggling Between Calls - Phone Call Features - Uconnect™ Phone — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Toggling Between Calls

If two calls are in progress (one active and one on hold), press the single beep, button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one call can be placed on hold at a time.

    Place/Retrieve A Call From Hold
    To put a call on hold, press the button until you hear a single beep. This indicates that the call is on hold. To bring the call back from hold, press and hold the button until you hear a s ...

    Conference Call
    When two calls are in progress (one active and one on hold), press and hold the button until you hear a double beep indicating that the two calls have been joined into one conference call. ...

    See also:

    When “CHECK DEVICE” is displayed
    This message is displayed under the following conditions. - When there is a short in the USB bus - When a non-corresponding device (for example a USB mouse) is connected - When a non-correspo ...

    Adjusting the set speed
    To change the set speed, operate the lever until the desired set speed is obtained. 1 Increase the speed 2 Decrease the speed Hold the lever until the desired speed setting is obtained. Fine a ...

    OFF position
    When the switch is in the OFF position 3 , the ceiling light will not illuminate, regardless of the condition. ...