Jeep Liberty: To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase speed by pushing the RES (+) button. If the button is continually pressed, the set speed will continue to increase until the button is released, then the new set speed will be established.
Pressing the RES (+) button once will result in a 1 mph (2 km/h) increase in set speed. Each subsequent tap of the button results in an increase of 1 mph (2 km/h).
To decrease speed while the Electronic Speed Control is set, push the SET (-) button. If the button is continually held in the SET (-) position, the set speed will continue to decrease until the button is released. Release the button when the desired speed is reached, and the new set speed will be established.
Pressing the SET (-) button once will result in a 1 mph (2 km/h) decrease in set speed. Each subsequent tap of the button results in a decrease of 1 mph (2 km/h).
To Resume Speed
To resume a previously set speed, push the RES (+)
button and release. Resume can be used at any speed
above 20 mph (32 km/h). ...
To Accelerate For Passing
Press the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills t ...
See also:
RSE menus
IntroductionSettings in the RSE menus can be made
from
the front center console control panel or by
using the remote control in the rear seat. A
source for one of the rear screens can be activ ...
Mirrors
Outside rearview mirror Be sure to adjust mirror angles before driving. Your
vehicle is equipped with both left-hand and right-hand outside rearview mirrors.
The mirrors can be adjusted remotely w ...
Extending Engine Run Time
For a 10-minute extension, repeat Steps 1 and 2 while the engine is still running.
The remote start can be extended once.
When the remote start is extended, the second 10 minutes will start immedia ...