Jeep Liberty: To Deactivate
A soft tap on the brake pedal, pushing the CANCEL button, or normal brake pressure while slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed memory. Pressing the ON/OFF button or turning the ignition switch OFF erases the set speed memory.
To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle
has reached the desired speed, press the SET (-) button
and release. Release the accelerator and the vehicle will
operate at the selected s ...
To Resume Speed
To resume a previously set speed, push the RES (+)
button and release. Resume can be used at any speed
above 20 mph (32 km/h). ...
See also:
Notes on driving
If the vehicle is heavily laden, check the tire pressures and correct them
if necessary.
When parking your vehicle, make sure that the tires do not get deformed
by the curb or other obstacl ...
Frequency Of Fluid Change
Under normal operating conditions, the fluid installed at
the factory will give satisfactory lubrication for the life of
the vehicle. Fluid changes are not necessary unless the
fluid becomes con ...
Center console, lower section
Stowage compartment Ashtray Cigarette lighter Power socket
Selector lever
Cup holder
Stowage compartment
Audio/COMAND controller
Selects the drive program
...