GMC Terrain: Tire Messages
SERVICE TIRE MONITOR SYSTEM
This message displays if there is a problem with the Tire Pressure Monitor System (TPMS). See Tire Pressure Monitor Operation on page 10‑54 for more information.
TIRE LEARNING ACTIVE
This message displays when the system is learning new tires. See Tire Pressure Monitor Operation on page 10‑54 for more information.
TIRE LOW ADD AIR TO TIRE
This message displays when the pressure in one or more of the tires is low.
This message also displays LEFT FRONT, RIGHT FRONT, LEFT REAR, or RIGHT REAR to indicate the location of the low tire. The low tire pressure warning light will also come on. See Tire Pressure Light on page 5‑20. If a tire pressure message appears on the DIC, stop as soon as you can. Inflate the tires by adding air until the tire pressure is equal to the values shown on the Tire and Loading Information label. See Tires on page 10‑44, Vehicle Load Limits on page 9‑16, and Tire Pressure on page 10‑51.
You can receive more than one tire pressure message at a time. The DIC also shows the tire pressure values. See Driver Information Center (DIC) on page 5‑23.
Service Vehicle Messages
SERVICE AC SYSTEM
This message is displayed if there is a problem with the air conditioning system.
Take the vehicle to your dealer for service.
SERVICE POWER STEERING
This message is displayed i ...
Transmission Messages
SERVICE TRANSMISSION
This message displays if there is a problem with the transmission. See your dealer.
SHIFT TO PARK
This message displays when the transmission needs to be shifted to P (Park).
...
See also:
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH ...
Headlamp control
Rotate the headlamp control to the
first position to turn on the
parking lamps.
Rotate to the second position
to
turn on the headlamps.
Rotate back to to turn the
headlamps off.
...
Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held transmitter
to HomeLink®, continue to push and hold
the HomeL ...