Mercedes-Benz GLK-Class: SmartKey
Display messages | Possible causes/consequences and Solutions |
![]() Key Does Not Belong to Vehicle |
You have put the wrong SmartKey in the ignition lock.
|
![]() Take Your Key from Ignition |
The SmartKey is in the ignition lock.
|
![]() Obtain a New Key |
The SmartKey needs to be replaced.
|
![]() Replace Key Battery |
The batteries of the KEYLESS-GO key are discharged.
|
![]() Don't Forget Your Key |
The display message is shown for a maximum of 60 seconds
and is only a reminder. You have opened the driver's door with the engine switched off. The KEYLESS-GO key is not in the ignition lock.
|
![]() Key Not Detected (red display message) |
The KEYLESS-GO key is not in the vehicle. A warning tone also sounds. If the engine is switched off, you can no longer lock the vehicle centrally or start the engine.
The KEYLESS-GO key is not detected while the engine is running because there is interference from a strong source of radio waves. A warning tone also sounds.
|
![]() Key Not Detected (White display message) |
The KEYLESS-GO key cannot be detected at present.
If the KEYLESS-GO key is still not detected:
|
![]() Key Detected in Vehicle |
The KEYLESS-GO key has been detected inside the vehicle
during locking.
|
![]() Remove 'Start' Button and Insert Key |
KEYLESS-GO is temporarily malfunctioning or is defective.
A warning tone also sounds.
|
![]() Close Doors to Lock Vehicle |
At least one door is open. A warning tone also sounds.
|
Vehicle
Display messages
Possible causes/consequences and Solutions
Shift to 'P' or 'N' to Start Engine
You have attempted to start the engine with the transmission
i ...
See also:
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Type A
Type B
The tire pressure monitoring system provides
the driver with the warning message
indicated by sending a signal from a
sensor that is installed in each wheel
when tire p ...
Engine block heater (if so equipped)
Engine block heaters are used to assist in cold
temperature starting.
The engine block heater should be used when
the outside temperature is 208F (−78C) or lower.
To use the engine block h ...
Sensor blockage
If one of the sensors is completely obscured
the BSM system is automatically disabled, the
warning indicator dot is displayed in the
exterior mirror and the message BSM sensor
blocked appears in t ...