Ford Escape: Running out of fuel - Roadside Emergencies - Ford Escape Owner's ManualFord Escape: Running out of fuel

If you have run out of fuel and need to refill the vehicle with a portable fuel container, see Running out of fuel in the Maintenance and Specifications chapter for proper fuel filling method using a portable fuel container and the included fuel filler funnel. Do not insert the nozzle of portable fuel containers or any type of aftermarket funnels into the Easy Fuel “no cap” fuel system as it can be damaged. You must use the included funnel in such circumstances.

or aftermarket funnels into the Easy Fuel system. This could WARNING: Do not insert the nozzle of portable fuel containers or aftermarket funnels into the Easy Fuel system. This could damage the fuel system and its seal, and may cause fuel to run onto the ground instead of filling the tank, all of which could result in serious personal injury.

    Wheel lug nut torque specifications
    Retighten the lug nuts to the specified torque within 100 miles (160 km) after any wheel disturbance (tire rotation, changing a flat tire, wheel removal, etc.). WARNING: When a wheel is installe ...

    Jump starting
    WARNING: The gases around the battery can explode if exposed to flames, sparks, or lit cigarettes. An explosion could result in injury or vehicle damage. WARNING: Batteries contain sulfuric acid ...

    See also:

    Flash-to-Pass
    The flash&-to&-pass feature works with the low beams or Daytime Running Lamps (DRL) on or off. To flash the high beams, pull the turn signal/lane change lever all the way toward you, then ...

    Brake System Indicator
    The brake system indicator normally comes on when you turn the ignition switch to the ON (II) position, and as a reminder to check the parking brake. It will stay on if you do not fully re ...

    Stage 1: Sealing the hole
    1. Open the cover on the tire sealing kit. 2. Peel off the speed limit sticker and affix it to the steering wheel hub where it will be clearly visible to the driver. 3. Ensure that the on/off sw ...