Jeep Liberty: RKE Linked To Memory — If Equipped
When on is selected, you can use your RKE transmitter to recall one of two pre-programmed memory profiles. Each memory profile contains desired position settings for the driver seat, side mirror and a set of desired radio station presets. When OFF is selected, only the memory switch on the driver’s door panel will recall memory profiles. To make your selection, press and release the SELECT button until “ON” or “OFF” appears. Refer to “Driver Memory Seat” in “Understanding The Features Of Your Vehicle” for more information.
RKE Unlock
When Driver Door 1st Press is selected, only the driver’s
door will unlock on the first press of the Remote Keyless
Entry (RKE) transmitter UNLOCK button. When Driver
Door 1st Press is selecte ...
Sound Horn With Lock
When on is selected, a short horn sound will occur when
the RKE transmitter LOCK button is pressed. This feature
may be selected with or without the Flash Lamp with
Remote Key Lock feature. To m ...
See also:
Interior lights
Room light Front (map light) The lights are turned ON or OFF by pressing the
corresponding switch.
Center (dome light) ➀ DOOR : The light turns on or off when a door is opened
or close ...
Ignition Off Operation
For vehicles not equipped with the Electronic Vehicle
Information Center (EVIC), the power sunroof switch
will remain active for 45 seconds after the ignition switch
is turned to the LOCK positi ...
Unable to Connect to OnStar Message
If there is limited cellular coverage or the cellular network has reached maximum
capacity, this message may come on. Push Q to try the call again or try again after
driving a few miles into anoth ...