Subaru Forester: Replacing an air filter
1. Remove the glove box.
(1) Open the glove box.
(2) Remove the damper shaft from the glove box.
(3) Pull out the glove box.
2. Remove the air filter.
3. Replace the air filter element with a new one.
The arrow mark on the filter must point UP.
4. Reinstall the glove box, and connect the damper shaft.
5. Close the glove box.
6. LABEL installation
(1) Fill out the information on the
service label (small).
1) Service label
(2) Attach the service label to the driver’s side door pillar.
1) Caution label
(3) Attach the caution label next to the air filter as shown in the illustration.
Air filtration system
Replace the filter element according to the replacement schedule as follows. This schedule should be followed to maintain the filter’s dust collection ability. Under extremely dusty conditio ...Audio
...See also:
Economical driving
For economical driving, there are some technical requirements that have to be
met. The prerequisite for low fuel consumption is a properly adjusted engine. In
order to achieve longer life of the v ...
Ride Control System Messages
ALL WHEEL DRIVE OFF
If your vehicle has the All-Wheel Drive (AWD) system, this message displays when
the rear drive system is overheating. This message turns off when the rear drive
system cools ...
Ashtray / coin tray
The front ashtray/coin tray may be opened by
pushing and releasing the ashtray lid. To remove
the ashtray to empty or clean it, lift the
ashtray upward and pull it out. The ashtray coin
tray ...