Range Rover Evoque: Removing the temporary spare wheel
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1. To access the temporary spare wheel, fold
forward the rear edge of the cover then
remove it.
2. Turn the temporary spare wheel locking
ring counter clockwise to gain access to
the retaining bolt.
3. Turn the retaining bolt counter clockwise
until it comes free.
4. Remove the temporary spare wheel.
READ NEXT:
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and r
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehic
Before raising the vehicle or changing a wheel,
ensure that you read and comply with the
following warnings.
Always find a safe place to
stop, off
the highway and away from traffic.
Ensure tha
SEE MORE:
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
General Information
Introduction
The body plays a significant role in the increasing trend of ever more
rapidly changing model variants. The different
customer groups are strongly influenced by the design and shape of the body. At
the same time the stability of the body
plays the most important pa
© 2011-2024 Copyright www.rrevoque.org