GMC Terrain: Power Liftgate 3/4 Mode
To program the liftgate opening height:
1. Turn the liftgate switch to either the MAX , or the 3/4 mode position and power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any liftgate switch. Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate adjacent to the latch until the turn signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the 3/4 mode selected, the liftgate stops at the new set position.
If there is no audible and visual feedback when setting the intermediate stop position, the liftgate height is being set below the 3/4 open height minimum (approximately 1.5 m or 5 ft). The liftgate cannot be set below that minimum and the new setting will not be recorded.
Obstacle Detection Features
If the liftgate encounters an obstacle during a power open or close cycle, a
warning chime will sound and the liftgate will automatically reverse direction to
the full closed or open position. Aft ...
Manual Operation of Power Liftgate
To change the liftgate to manual operation, turn the mode switch to the OFF position.
With the power liftgate disabled and all of the doors unlocked, the liftgate
can be manually opened and closed. ...
See also:
Useful information
This Operator's Manual describes all models and all standard and optional equipment
of your vehicle available at the time of publication of the Operator's Manual. Country-specific
diffe ...
Airbag System Check
The airbag system does not need regularly scheduled maintenance or replacement.
Make sure the airbag readiness light is working. See Airbag Readiness Light on page
5‑11 for more information. ...
Heating controls
For normal heating operation, set the air intake
control to the fresh air () position and
the
air flow control to the floor ()
position.
For faster heating, the air intake control should
...