Range Rover Evoque: Pairing and connecting from the touch screen

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Telephone / Pairing and connecting from the touch screen

1. Switch on your mobile phone’s Bluetooth® connection. Make sure that your mobile phone is in Bluetooth® discoverable mode, sometimes referred to as find me mode (see your phone’s operating instructions for more information).

2. Switch the ignition on and ensure that the touch screen is active.

3. From the home menu select Phone.

4. A menu will appear. Select Search new.

5. Select Vehicle to device option.

6. Identify your phone from the displayed list and select the corresponding Pair and connect option.

Note: If more than 5 devices are detected, it may be necessary to use the scroll bar to see the entire list.

7. When prompted, enter the PIN code into your phone. See your phone’s operating instructions for further information.

8. Once your phone is paired and connected to the system, a confirmation message will be displayed before switching to the Digit Dial screen.

Note: Due to the duration of a Bluetooth® search, it is advised that the timeout to home screen feature is switched off before attempting to search for Bluetooth® devices.
This setting can be changed within Vehicle, Syst settings, Display set, Timeout to home screen.

READ NEXT:

 Changing the connected phone

Up to 10 mobile phones can be paired with the vehicle in the same way. However, only one can be connected and ready for use as a phone at any one time. To connect a different paired phone, follow

 Touch screen icons

Connect. Use to send or accept a call and access last 10 dialled numbers. Disconnect. Use to end or reject a call. No phone connected. Phone signal strength indicator. Phone battery l

 Steering wheel icons

Connect. Press and release to send or accept a call or to access the last 10 dialled list. Press and hold to access the phonebook. Disconnect. Use to end or reject a call. Voice control t

SEE MORE:

 Interior lights locations

Interior lights locations 1. Sun visor lamps. Illuminates when the vanity mirror is opened. 2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off. Note: If you are wearing gloves, it may be necessary to touch the lens to operate the lamps. 3. Front int

 Electric windows and panoramic roof blind

Electric windows and panoramic roof blind 1. Briefly pull a switch fully up and release, the window will continue to rise until fully closed. Briefly press a switch fully down and release, the window will continue to lower until fully open. Pressing or pulling a switch again will stop the wi

© 2011-2024 Copyright www.rrevoque.org