Jeep Liberty: Normal Starting
NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.
Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
Tip Start Feature
Turn the ignition switch to START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds. If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
Starting Procedures
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
• When leaving the vehicle, always remove the key
fob from the ign ...
Extreme Cold Weather (Below –20°F Or –29°C)
To ensure reliable starting at these temperatures, use of
an externally powered electric engine block heater (available
from your authorized dealer) is recommended. ...
See also:
Stage 2: Checking inflation pressure
1. Connect the tire sealing system as described
in stage 1.
2. Refer to the inflation pressure table in this
chapter for the correct inflation pressure. If
the tire needs to be inflated, start ...
Storing Radio Station Presets
There are a few ways to store presets.
Up to 36 preset stations can be stored. AM, FM, and XM, if equipped, can be mixed.
1. From the AM, FM, or XM main page, press and hold one of the preset screen ...
Three-point type seat belt
- Every person who drives or rides in
this vehicle should use a seat belt at
all times.
- Do not ride in a moving vehicle
when the seatback is reclined. This
can be dangerous. The shoulder ...