Jeep Liberty: Windshield Washers
To use the washer, pull the windshield wiper/washer control lever toward you and hold it for as long as washer spray is desired (for a maximum of 10 seconds).
If you activate the washer while the wiper control is in the delay range, the wipers will operate in low-speed for two or three wipe cycles after releasing the lever and then resume the intermittent interval previously selected.
If you activate the washer while the wiper control is in the off position, the wipers will operate for two or three wipe cycles and then turn off.
WARNING!
Sudden loss of visibility through the windshield
could lead to a collision. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with defroster before and during windshield
washer use.
Intermittent Wiper System
Use the intermittent wiper system when weather conditions
make a single wiping cycle with a variable pause
between cycles desirable. Rotate the end of the windshield
wiper/washer control lever t ...
Mist Feature
Push downward on the windshield wiper/washer control
lever to activate a single wipe cycle to clear the
windshield of road mist or spray from a passing vehicle.
The wipers will continue to operat ...
See also:
Corresponding profiles for the cell phone
- HFP (Hands Free Profile): Ver. 1.0
- OPP (Object Push Profile): Ver. 1.1 ...
Reporting safety defects in the U.S.
If you believe that your vehicle has a
defect which could cause a crash or
could cause injury or death, you
should immediately inform the
National Highway Traffic Safety
Administration (NHTS ...
Operating tips
To get the best performance out of the NISSAN
Voice Recognition system, observe the following:
- Keep the interior of the vehicle as quiet as
possible. Close the windows to eliminate
surroundi ...
