Subaru Forester: Vehicle Dynamics Control OFF switch
Vehicle Dynamics Control OFF switch
Pressing the switch to deactivate the
Vehicle Dynamics Control system can
facilitate the following operations:
- a standing start on a steeply sloping
road with a snowy, gravel-covered, or
otherwise slippery surface
- extrication of the vehicle when its
wheels are stuck in mud or deep snow
When the switch is pressed during engine operation, the Vehicle Dynamics Control OFF indicator light on the combination meter illuminates. The Vehicle Dynamics Control system will be deactivated and the vehicle will behave like a model not equipped with the Vehicle Dynamics Control system. When the switch is pressed again to reactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control OFF indicator light turns off.
With the Vehicle Dynamics Control system deactivated, traction and stability enhancement offered by Vehicle Dynamics Control system is unavailable. Therefore you should not deactivate the Vehicle Dynamics Control system except under above-mentioned situations.
NOTE
- The Vehicle Dynamics Control system
will be activated automatically
when the engine is started.
- If the switch is held down for 10 seconds or longer, the indicator light turns off, the Vehicle Dynamics Control system is activated, and the system ignores any further pressing of the switch. To make the switch usable again, turn the ignition switch to the “LOCK” position and restart the engine.
- When the switch is pressed to deactivate the Vehicle Dynamics Control system, the vehicle’s running performance is comparable with that of a vehicle that does not have a Vehicle Dynamics Control system. Do not deactivate the Vehicle Dynamics Control system except when absolutely necessary.
- Even when the Vehicle Dynamics Control system is deactivated, components of the brake control system may still activate. When the brake control system is activated, the Vehicle Dynamics Control operation indicator light illuminates.
Vehicle Dynamics Control system monitor
Refer to “Vehicle Dynamics Control warning
light/Vehicle Dynamics Control operation
indicator light” and “Vehicle
Dynamics Control OFF indicator light”. ...
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Type A
Type B
The tire pressure monitoring system provides
the driver with a warning message
by sending a signal from a sensor that is
installed in each wheel when tire pressure
is s ...
See also:
General information
The program selector button allows you to choose between different driving characteristics.
Program selector button
For further information on the automatic drive program, see ().
Press p ...
Stopping the engine
The ignition switch should be turned off
only when the vehicle is stopped and the
engine is idling.
Do not stop the engine when the
vehicle is moving. This will cause
loss of power to the ...
Brakes
This vehicle has disc brakes. Disc brake pads have built-in wear indicators that
make a high-pitched warning sound when the brake pads are worn and new pads are
needed. The sound can come and go o ...
