Nissan Rogue: Vehicle Dynamic Control (VDC) OFF switch
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions.
If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor.
If maximum engine power is needed to free a stuck vehicle, turn the VDC system off.
To turn off the VDC system, push the VDC OFF
switch. The 
indicator will illuminate.
Push the VDC OFF switch again or restart the engine to turn on the system. (See “Vehicle Dynamic Control (VDC) system” in the “5.
Starting and driving” section.)
Heated seats (if so equipped)
Do not use or allow occupants to use
the seat heater if you or the occupants
cannot monitor elevated seat temperatures
or have an inability to feel pain in
those body parts in contact with ...
Power outlet
Instrument panel
Center console (if so equipped)
The power outlet is located in the instrument
panel and the center console (if so equipped).
- The outlet and plug may be hot
during o ...
See also:
Service menu
In the Service menu you can:
call up display messages ()
restart the tire pressure loss warning system (Canada only) ()
check the tire pressure electronically (USA only) ()
call up the ser ...
Emergency maneuvers
• In an unavoidable emergency situation where a sudden sharp turn
must be made, remember to avoid “over-driving” your vehicle, i.e.,
turn the steering wheel only as rapidly and as far as requi ...
Interior lights
When leaving your vehicle, make sure the
lights are turned off to avoid battery
discharge. ...
