Volvo XC60: Using City Safety
NOTE
The City Safetyâ„¢ function is activated automatically
each time the engine has been
switched off and restarted.
On and Off
In certain situations, it may be desirable to switch City Safetyâ„¢ off, such as when driving in close quarters where leaves, branches, etc.
may obscure the hood and windshield.
When the engine is running, City Safetyâ„¢ can be switched off as follows:
Press My Car in the center console control panel and go to Settings Car settings Driver support systems City Safety.
Select Off.
If the engine is switched off, City Safetyâ„¢ will reactivate when the engine is restarted.
WARNING
The laser sensor emits light when the ignition
is in mode II or higher, even if City
Safetyâ„¢ has been switched off.
To switch City Safetyâ„¢ on again:
• Follow the same procedure as for switching City Safety™ off but select ON.
Function
Location of the laser sensor in the windshield City Safetyâ„¢ monitors traffic ahead of you using a laser sensor mounted in the upper section of the windshield. If a collision is imminent, Ci ...Limitations
The sensor used by City Safetyâ„¢ is designed to detect cars and other larger motor vehicles ahead of your vehicle in both daylight and darkness. However, there are certain limitations and the ...See also:
Parksense Display
When the vehicle is in REVERSE, the warning display
will turn ON indicating the system status.
Park Assist ON
Park Assist Off
The system will indicate a detected obstacle by showing
three s ...
Ignition Switch
The ignition switch has four
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
LOCK (0) - You can insert or
remove the key only in this position.
To turn the key, the shift lev ...
Interior Glass
To clean, use a terry cloth fabric dampened with water. Wipe droplets left behind
with a clean dry cloth. Commercial glass cleaners may be used, if necessary, after
cleaning the interior glass wit ...