Nissan Rogue: Training procedure - Speaker Adaptation (SA) mode - Bluetooth® Hands-Free Phone System (if so equipped) - Center display, heater, air conditioner, audio, phone and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: Training procedure

1. Position the vehicle in a reasonably quiet outdoor location.

2. Sit in the driver’s seat with the engine running, the parking brake on, and the transmission in Park.

3. Push and hold the 5 seconds. button for more than 5 seconds.

4. The system announces: “Push the PHONE SEND ( button for the hands-free ) button for the hands-free phone system to enter the speaker adaptation mode or push the PHONE END (button to select a different language.” ) button to select a different language.” 5. Push the button. button.

For information on selecting a different language, see “Choosing a language” earlier in this section.

6. If the connected phone is already in use, the system will prompt you to overwrite. Follow the instructions provided by the system.

7. When preparation is complete and you are ready to begin, push the 8. The SA mode will be explained. Follow the button.

8. The SA mode will be explained. Follow the instructions provided by the system.

9. When training is finished, the system will tell you an adequate number of phrases have been recorded.

10. The system will announce that speaker adaptation has been completed and the system is ready.

The SA mode will stop if:
- The is pushed for more than 5 button is pushed for more than 5 seconds in SA mode.

- The vehicle is driven during SA mode.

- The ignition switch is turned to the OFF or LOCK position.

    Speaker Adaptation (SA) mode
    Speaker Adaptation allows up to two out-of dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own ...

    Training phrases
    During the SA mode, the system instructs you to say the following phrases. (The system will prompt you for each phrase.) - phonebook transfer entry - dial 3 0 4 2 9 - delete call back number ...

    See also:

    U.S. DOT Tire Identification Number (TIN)
    Both U.S. and Canada Federal regulations require tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characte ...

    Interior Care
    To prevent dirt particle abrasions, regularly clean the vehicle's interior. Immediately remove any soils. Note that newspapers or dark garments that can transfer color to home furnishings can ...

    Windshield Wiper
    1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until ...