Jeep Liberty: Towing Requirements – Tires - Towing Requirements - Trailer Towing - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: Towing Requirements – Tires

− Do not attempt to tow a trailer while using a compact spare tire.

− Proper tire inflation pressures are essential to the safe and satisfactory operation of your vehicle. Refer to “Tires – General Information” in “Starting and Operating” for information on tire pressures and for proper tire inflation procedures.

− Check the trailer tires for proper tire inflation pressures before trailer usage.

− Check for signs of tire wear or visible tire damage before towing a trailer. Refer to “Tires – General Information” in “Starting and Operating” for information on tread wear indicators and for the proper inspection procedure.

− When replacing tires, refer to “Tires – General Information” in “Starting and Operating” for information on replacement tires and for the proper tire replacement procedures. Replacing tires with a higher load carrying capacity will not increase the vehicle’s GVWR and GAWR limits.

    Towing Requirements
    To promote proper break-in of your new vehicle drivetrain components, the following guidelines are recommended: CAUTION! • Do not tow a trailer at all during the first 500 miles (805 km) the ...

    Towing Requirements – Trailer Brakes
    − Do not interconnect the hydraulic brake system or vacuum system of your vehicle with that of the trailer. This could cause inadequate braking and possible personal injury. − An ele ...

    See also:

    Servicing air conditioner
    The air conditioner system contains refrigerant under high pressure. To avoid personal injury, any air conditioner service should be done only by an experienced technician with the prope ...

    Emissions inspection and maintenance programs
    In some localities, it may be a legal requirement to pass an inspection of your vehicle’s emissions control system. Failure to pass could prevent vehicle registration. For states that require ...

    Extra high beam
    1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the cover over the bulbs (see page 323). 3. Disconnect the wiring connector from the bulb holder. 4. Remove the bu ...