Nissan Rogue: Shift lock release
Shift lock release
If the battery charge is low or discharged, the selector lever may not be moved from the P (Park) position even with the brake pedal depressed and the selector lever button pushed.
To move the selector lever, release the shift lock.
The selector lever can be moved to the N (Neutral) position. This allows the vehicle to be moved if the battery is discharged.
To release the shift lock, perform the following
procedure:
1. Turn the ignition switch to the LOCK
position, and remove the key if it is inserted.
2. Apply the parking brake.
3. Remove the shift lock release cover A using a suitable tool.
4. Push down the shift lock release B using a suitable tool.
5. Push the selector lever button C and move the selector lever to the N (Neutral) position D while holding down the shift lock release.
Turn the ignition switch to the ON position. The vehicle may be moved to the desired location.
Replace the removed shift lock release cover after the operation.
If the selector lever cannot be moved out of the P (Park) position, have a NISSAN dealer check the CVT system as soon as possible.
If the selector lever cannot be moved from the P (Park) position while the engine is running and the brake pedal is depressed, the stop lights may not work. Malfunctioning stop lights could cause an accident injuring yourself and others.
Fail-safe
If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may illuminate to indicate the f ...Parking brake
- Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident. - Do not release the parking brake from outside the vehicle ...See also:
Towing the vehicle on four wheels
If the vehicle battery is
disconnected or
disabled, do NOT attempt to tow the
vehicle. Towing may result in serious
damage to the transmission.
The vehicle should NOT be towed on all four
whee ...
Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the retaining clamps by pressing
them to the sides.
2. Pull the cover straight out.
Reinstall the cover in the reverse order. ...
Supported MP3 File Formats
The radio will recognize only files with the *.MP3 extension
as MP3 files. Non-MP3 files named with the *.MP3
extension may cause playback problems. The radio is
designed to recognize the file a ...