Mercedes-Benz GLK-Class: Replacing the windshield wiper blades
Removing the wiper blades
Before changing the wiper blades, always set the wiper arms to a vertical position using the combination switch. There is otherwise a risk of damaging the hood.
Moving the wiper blades to a vertical position
Vehicles without KEYLESS-GO
- Turn the SmartKey to position 1 or 2 in the ignition lock.
- Set the windshield wipers to position .
- When the wiper arms have reached a vertical position, turn the SmartKey to position 0 and remove it from the ignition lock.
Vehicles with KEYLESS-GO
- Switch off the engine.
- Remove your foot from the brake pedal.
- Set the windshield wipers to position .
- Press the Start/Stop button repeatedly until the windshield wipers start.
- When the wiper arms have reached a vertical position, press the Start/Stop button.
Removing the wiper blades
- Fold the wiper arm away from the windshield until it engages.
- Set the wiper blade at right angles to the wiper arm.
- Remove the wiper blade from the retaining pin on the wiper arm in the direction of the arrow.
Installing the wiper blades
- Push the new wiper blade onto the retaining pin on the wiper arm in the opposite direction to the arrow. Make sure that the wiper blade slides fully onto the retaining pin on the wiper arm.
- Turn the wiper blade parallel to the wiper arm.
- Fold the wiper arm back onto the windshield.
Important safety notes
WARNING For safety reasons, switch off the windshield wipers and remove the key from the ignition lock before changing the wiper blades (vehicles with KEYLESS-GO: make sure that the on-board ...Replacing the rear window wiper blade
Removing the wiper blade Remove the SmartKey from the ignition lock. Fold wiper arm 1 away from the rear window until it engages. Position wiper blade 2 at a right angle to wiper arm 1. Ho ...See also:
Parking Brake
To set the parking brake, hold the regular brake pedal down, then push the parking
brake pedal down.
If the ignition is on, the brake system warning light will come on. See Brake
System Warning ...
Drip wipe
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled ...
Limitations
The sensor used by City Safetyв„ў is designed
to detect cars and other larger motor vehicles
ahead of your vehicle in both daylight and darkness.
However, there are certain limitations and the
...