Range Rover Evoque: Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a replacement 3.3
volt, CR1/3N battery. Replace the cover and
rotate it to lock it closed.
READ NEXT:
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Removal
NOTES:
The A- Pillar reinforcement is manufactured from DP600, it is serviced
with its upper and lower door hinge mounting
brackets.
The A-Pillar reinforcement is unpicked from the side panel reinforcement
'ring-frame', it is not serviced separately.
If the A-pillar reinforcement is dama
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
© 2011-2024 Copyright www.rrevoque.org