Range Rover Evoque: Replacement sensor
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyre pressure monitoring system / Replacement sensor
Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The vehicle needs to be stationary for 15 minutes during the sensor fitment before the system is ready to detect the new sensor.
The vehicle must be driven for a minimum of fifteen minutes after the sensor change, and then remain stationary for fifteen minutes to activate full TPM system operation.
If the TPM system warning for any wheel does not clear, even after ensuring correct inflation and driving for more than ten minutes above 25 km/h (18 mph), you should seek qualified assistance as soon as possible.
READ NEXT:
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
Safety information
Some tyre damage may only be
partially sealed, or may not seal at
all, depending on the amount and type
of damage. Any loss of tyre pressure
can seriously affect vehicle safety.
Do not use the t
SEE MORE:
Coolant level check
Running the engine without
coolant will
cause serious engine damage.
The coolant level in the expansion tank should
be checked at least weekly (more frequently in
high mileage or arduous operating conditions).
Always check the level when the system is
cold.
Ensure the coolant level remai
Rear loadspace
Never allow passengers to
travel in
the loadspace under any
circumstances. All vehicle occupants
should be seated correctly and wear a
seat belt at all times when the vehicle
is in motion.
Always ensure that objects carried
within the vehicle are secured
properly.
To remove the loadspa
© 2011-2024 Copyright www.rrevoque.org
